OPERATING PROCEDURES
6-5
Models 345, 346, 349, 355 NPR
Operating Procedures
6
18. Place the large rubber gasket into the groove on the
back side of the freezer door.
Figure 6-16
19. Slide the white, plastic front bearing onto the bearing
hub, making sure that the flanged end of the bearing
is resting against the freezer door. Do not lubricate
the door gasket or front bearing.
Figure 6-17
20. Position the freezer door onto the four studs on the
front of the freezing cylinder and push the door into
place. Install the four handscrews onto the studs, and
tighten them equally in a crisscross pattern to ensure
that the door is snug. Do not overtighten the
handscrews.
Note: If the freezer door does not fit into place
easily, position the open end of the beater assembly
in the 11 o’clock position.
Figure 6-18
21. Position the baffle arm by inserting it down into the
hole on the baffle assembly that protrudes from the
door. Verify proper installation by moving the baffle
arm back and forth to make sure it moves freely.
Figure 6-19
To Next Page
Loading...