Taylor 444 - Parts Replacement Schedule

Section 9
9-1
Models 441 & 444
Parts Replacement Schedule
9
Parts Replacement Schedule
Table 9-1
Part Description Every 3 Months Every 4 Months Every 6 Months Annually
Scraper Blades X
Drive Shaft Seal X
Freezer Door Gasket X
Front Bearing X
Draw Valve O-rings X
Brush, 3” x 7” Inspect and replace
if necessary
Minimum
Brush, 1” x 2” Inspect and replace
if necessary
Minimum
Black Bristle Brush, 1” x 2” Inspect and replace
if necessary
Minimum
Double-Ended Brush Inspect and replace
if necessary
Minimum