Taylor 490 - Draining the Unit

23
Model 490 Troubleshooting Guide
PROBLEM PROBABLE CAUSE REMEDY PAGE
REF.
10. No freezer operation after
placing the unit in “AUTO”.
a. Unit unplugged. a. Plug into wall receptacle.
---
b. Circuit breaker off or
blown fuse.
b. Turn breaker on or
replace fuse.
---
c. Beater motor out on reset. c. Allow the motor to cool.
10
d. The draw arm is not
activated.
d. After placing the freezer in
the AUTO mode, the draw
arm must be raised to
activate the AUTO cycle.
16
11. Product not feeding into
freezing cylinder.
a. Inadequate level of mix in
the mix hopper.
a. Fill the mix hopper with
mix.
16
b. Mix inlet hole frozen. b. Mix hopper temperature
needs adjustment. Call
service technician.
---