Taylor 702 User Manual

24
Troubleshooting Guide
Models 702/741/772
Section 8 Troubleshooting G uide
PROBLEM PROBABLE CAUSE REMEDY PAGE
REF.
1. No product being
dispensed with the draw
valve open and the control
switch in AUTO.
a. The freezer door is
installed upside down.
a. Install the door correctly. 16
b. There is a freeze-up in the
mix inlet hole.
b. Call service technician to
adjust the hopper
temperature.
-- --
c. The beater motor is out on
reset.
c. Reset the freezer. 13
d. The beater is rotating
counterclockwise.
d. Contact service technician
to correct the rotation to
clockwise.
-- --
e. The draw valve is
connected to the draw
arm incorrectly.
e. The draw valve bracket
must be correctly attached
to the draw arm.
17
f. The circuit breaker is off
or the fuse is blown.
f. Turn the breaker on or
replace the fuse.
-- --
g. There is inadequate mix in
the hopper.
g. Fill the hopper with mix. 19
2. The product is too cold. a. The temperature control is
set too cold.
a. Adjust the temperature
control knob warmer.
14
b. The draw handle is not
fully closed.
b. The draw handle must be
fully closed.
-- --
3. The product appears too
soft.
a. The temperature control is
set too warm.
a. Adjust the temperature
control knob colder.
14
b. There is not enough air
space around the unit.
(A/C)
b. Allow for adequate air flow
across the condenser.
1
c. The scraper blade(s) are
worn.
c. Replace scraper blades
regularly.
27
d. Dirty condenser . d. Clean regularly. 23
e. The mix is out of date. e. Use only fresh mix. -- --
f. The beater is rotating
counterclockwise.
f. Contact service technician
to correct rotation to
clockwise.
-- --
g. Loss of water (W/C) g. Locate cause of water
loss and correct.
23

Taylor 702 Specifications

General

Brand	Taylor
Model	702
Category	Freezer
Language	English