16
Model 793Operating Procedures
Step 8
Insert the baffle rods through the opening in the
beaters and seat the door flush with the freezing
cylinder. With the door seated on the freezer studs,
install the handscrews. The short handscrews go on
the bottom and the long handscrews go on the top.
Tighten equally in a crisscross pattern to ensure the
door is snug.
Figure 11
Step 9
Install the draw valves. Slide the two o-rings into the
grooves on the draw valves and lubricate.
Figure 12
Step 10
Lubricate the inside of the freezer door spouts, top
and bottom. Insert the draw valves from the bottom
until the slot in the draw valves comes into view.
Figure 13
Step 11
Install the adjustable draw handles. Slide the o-ring
into the groove on the pivot pin and lubricate.
Figure 14
To Next Page
Loading...
