Taylor 793 - Parts Replacement Schedule

28
Model 793Parts Replacement Schedule
Section 9 Parts Replacement Schedule
The following wear items should be replaced by the operator per the schedule below.
PART DESCRIPTION EVERY
3MONTHS
EVERY
6MONTHS
ANNUALLY
Drive Shaft Seal X
Scraper Blade X
Freezer Door Gasket X
Front Bearing X
Draw Valve O- Ring X
Pivot Pin O- Ring X
Air Tube O- Ring X
White Bristle Brush, 3” x 7” Inspect & Replace
if Necessary
Minimum
White Bristle Brush, 1” x 2” Inspect & Replace
if Necessary
Minimum
Black Bristle Brush, 1” x 2” Inspect & Replace
if Necessary
Minimum
Double- Ended Brush Inspect & Replace
if Necessary
Minimum
Refer to Parts List on page 34 when ordering the above parts.