19
Model 793 Operating Procedures
Step 5
Place the power switch in the ON position.
Figure 23
Step 6
Press the WASH key. This will cause the sanitizing
solution in the freezing cylinder to agitate. Allow it to
agitate for five minutes.
Figure 24
Step 7
Place an empty pail beneath the door spouts.
Figure 25
Step 8
Open the center and side draw valve. Draw off all
the sanitizing solution.
Step 9
Once the sanitizer stops flowing from the door
spouts, raise the draw handles and press the WASH
key, cancelling the beater motor operation.
Repeat steps 1 - 9 for the other side of the unit.
Note: You have just sanitized the unit. Be sure
your hands are sanitized before continuing these
instructions.
To Next Page
Loading...
