How to remove a stuck drive shaft from the drive coupling in my Taylor Ice Cream Maker?
If the drive shaft is stuck in the drive coupling, it could be due to mix and lubricant accumulation; regularly brush clean the rear shell bearing area. Rounded corners on the drive shaft or coupling can also cause this, so replace worn components. Finally, a misaligned gear box can be the culprit; re-align it.
What causes scored freezing cylinder walls in my Taylor Ice Cream Maker?
Scored freezing cylinder walls can be caused by a missing or worn front bearing; install or replace it. Broken beater pins (pump style freezers only) can also cause this, so replace the beater assembly, ensuring scraper blades are properly attached over the pins. A bent beater assembly should be replaced. Finally, a misaligned gear box can contribute; re-align it.
Why is product collecting on top of the freezer door of my Taylor Ice Cream Maker?
If product is collecting on top of the freezer door, the top o-ring on the draw valve might be improperly lubricated or worn; lubricate it properly or replace the o-ring.
What to do if the pump won't operate in PUMP mode on my Taylor Ice Cream Maker?
If the pump won't operate in PUMP mode, try pushing the reset button. If that doesn't work, the membrane switch may be defective and need replacement.
Why are the MIX LOW and MIX OUT probes not working on my Taylor Ice Cream Maker?
If the MIX LOW and MIX OUT probes aren't functioning, there might be milkstone build-up in the hopper. Clean the hoppers thoroughly.
What to do if my Taylor Ice Cream Maker is not dispensing product?
If your Taylor Ice Cream Maker isn't dispensing product, several factors could be at play. First, ensure the mix hopper isn't low; if the MIX OUT light is on, add mix. Next, verify the power switch is in the ON position and press the AUTO keypad. If the beater motor is out on reset, allow it to cool, turn the power switch OFF, press the reset button, turn the power switch ON, and press the WASH keypad, checking that the drive shaft turns CLOCKWISE. Then press the AUTO keypad. Also, check the air/mix pump assembly, ensuring it's correctly assembled and properly lubricated. Confirm the spring and poppet are correctly installed on the mix inlet fitting, replacing if necessary. If the mix pump ball crank is broken, replace it. Ensure the pump motor is activated by pushing the reset button and ...
Guidelines for safe installation practices and personal protective equipment.
Guidelines for safe electrical hookup according to national and local codes.
Information and precautions regarding the machine's refrigerant.
Details warranty limitations for refrigeration compressors due to refrigerant changes.
Indicates low mix level in the hopper. Requires immediate refilling.
Activates the mix hopper refrigeration system for temperature control.
Activates the beater motor for cleaning cycles.
Activates the main refrigeration system for normal operation.
Controls the main power to the Softech™ control panel.
Allows adjustment of portion size and flow rate for dispensing product.
Step-by-step instructions for assembling the freezer parts after cleaning.
Procedure for cleaning and sanitizing the freezer components with a sanitizing solution.
Procedure for filling the freezing cylinder with mix after cleaning and sanitizing.
Detailed steps for thoroughly cleaning all parts of the freezer.
Instructions for taking apart the freezer for cleaning and maintenance.
Specific instructions for manual cleaning using brushes as per regulations.
Key checkpoints for ensuring proper daily cleaning and sanitizing procedures.
Steps to take when dealing with high bacterial or coliform counts.
Troubleshooting steps for when no product dispenses with draw valve open.
To Next Page
General
