Taylor C708 - Page 42

38
Models C708 & C716Operating Procedures
Step 4
Insert the piston into the retaining pin hole end of the
pump cylinder. (See Figure 32.)
Figure 32
Step 5
Assemble the valve cap. Slide the o-ring into the
groove of the valve cap. DO NOT lubricate the
o-ring. (See Figure 33.)
Figure 33
Step 6
Slide the pump valve gasket into the holes on the
cap. DO NOT lubricate the gasket. (See Figure 34.)
Figure 34
Step 7
Insert the valve body cap into the hole in the mix
inlet adapter. (See Figure 35.)
Figure 35
Step 8
Insert the mix inlet assembly into the pump cylinder.
(See Figure 36.)
Figure 36
The adapter must be positioned into the notch
located at the end of the pump cylinder.