What to do if my Taylor Frigomat CH02 doesn't start?
If your Taylor Heating System doesn't start, there could be a few reasons. First, check if the master switch is open and close it. If the switch is closed, there may be an electrical anomaly or blown fuses, in which case you should contact a technician.
Why is my Taylor Frigomat CH02 Heating System taking so long to heat?
If your Taylor Heating System is taking a long time to heat, it could be due to several factors. Ensure you are working with at least half the maximum amount of product allowed. Also, make sure the lid is properly assembled and closed. If these aren't the cause, there may be a faulty resistance or fluid pump, requiring a technician's attention.
What to do if my Taylor Frigomat CH02 Heating System is noisy during operation?
If your Taylor Heating System becomes noisy during operation, the transmission shaft may need lubrication. To resolve this, remove the mixer, pull the transmission shaft upwards, and lubricate it with food grease.
What to do if my Taylor Heating System is noisy and the beater stops?
If your Taylor Heating System becomes noisy and the beater stops, the belt might be slipping. You should contact a technician to check the belt tension and possibly replace it.
What to do if there is too much product in the vessel of my Taylor Frigomat CH02 Heating System after extraction?
If there's too much product in the vessel after extraction from your Taylor Heating System, it might be due to insufficient rear feet adjustment. Adjust the rear feet so that the product contained in the vessel comes out.
What to do if my Taylor Frigomat CH02 Heating System doesn't heat within normal time and I see blue fluid underneath?
If your Taylor Heating System does not heat within the normal time and you notice a loss of blue fluid under the machine, this indicates a loss of glycol from the system. Contact the technician.
General| Brand | Taylor |
|---|---|
| Model | Frigomat CH02 Series |
| Category | Heating System |
| Language | English |
To Next Page