CCoommppoonneennt t PPrroobblleem m CCoorrrreeccttiioonn
4. 4. IgniIgnition tion SwiSwitchtch
(Continued)(Continued)
(Continued)(Continued)
connected to the terminals of theconnected to the terminals of the
batteriesbatteries. . Ensure that Ensure that the batter-the batter-
ies are ies are charged. charged. Ensure that Ensure that cir-cir-
cuit breaker (CB1) can maintain acuit breaker (CB1) can maintain a
set state. set state. If 12 VDC If 12 VDC is presis present,ent,
turn the ignition switch (S1) to theturn the ignition switch (S1) to the
Start posiStart position. tion. Check tCheck the S termihe S termi--
nal of the ignition switch for 12nal of the ignition switch for 12
VDC. VDC. If not prIf not present, reesent, remove themove the
wire from the S terminal; turn thewire from the S terminal; turn the
ignition switch to the Start positionignition switch to the Start position
and check for 12 VDC at the S ter-and check for 12 VDC at the S ter-
minminal. al. If 12 VDC is preIf 12 VDC is presentsent, the, the
ignition switch is good.ignition switch is good.
5. 5. WiWireress
1. 1. WWiirre e hahas s llosost t cconontitinunuiittyy. . 1. 1. IIssololaate te tthe he wwiirre e ffrroom m tthe he cciirrccuiuitt
(ohm out the wir(ohm out the wire). e). Ohms wilOhms will varyl vary
according to the length of the wire.according to the length of the wire.
Expect to see low ohms if wire isExpect to see low ohms if wire is
good.good.
To Next Page
Loading...