TX / TXH / TXB 180S - 400L (Rev. 4/23/07)TX / TXH / TXB 180S - 400L (Rev. 4/23/07)
6-466-46
Lift (Max Setting) ScreenLift (Max Setting) Screen
7.7. The Max parThe Max parameter of Lameter of Lift is useift is used to calibrd to calibrate the maxate the maximum amimum amount of curount of current sent trent sent to the lift vao the lift valvelve
when lifting. when lifting. The desired setting is the value tThe desired setting is the value that no noticeable increase in speed is obthat no noticeable increase in speed is obtained after theained after the
value is exceeded. value is exceeded. Ensure that the Max value Ensure that the Max value is highlighted on the upper right side of is highlighted on the upper right side of the displaythe display
(depress the OK button if the (depress the OK button if the Min value is highlighted). Min value is highlighted). With the engine running, fully actWith the engine running, fully actuate the joys-uate the joys-
tick to the lift up position. tick to the lift up position. Slowly depress the UP or DOWN button until there is Slowly depress the UP or DOWN button until there is no noticeable increaseno noticeable increase
in the speed at which tin the speed at which the carriage moves. he carriage moves. Depress the OK button to Depress the OK button to store the value into the store the value into the proces-proces-
sor and depress thesor and depress the ←←button (back) to go back to the Adjust Groups screen.button (back) to go back to the Adjust Groups screen.
8.8. Repeat tRepeat these prochese procedures fedures for adjustor adjusting the seting the setting(sting(s) of the other TI) of the other TICS systCS system paramem parameters.eters.
The ignition switch should be turned to The ignition switch should be turned to its Off position after its Off position after maintenancemaintenance
personnel have made setting personnel have made setting adjustments within the TIadjustments within the TICS system. CS system. Failure to do so, giFailure to do so, givesves
Unauthorized personnel access to change settings within the TICS system.Unauthorized personnel access to change settings within the TICS system.
Valve Current Default SettingsValve Current Default Settings
AAddjjuussttmmeennt t GGrroouupp DDeeffaauullt t SSeettttiinnggss
Hoist - Up (+) / Down (Hoist - Up (+) / Down (
)) MMiin n -- 88000 0 / / 660000
MMax ax -- 151500 00 / 1/ 1070755
Start - 250 / 0Start - 250 / 0
Stop - 250 / 250Stop - 250 / 250
Tilt - Out (+) / In (Tilt - Out (+) / In (
)) MMiin n -- 77550 0 / / 775500
MMax ax -- 151500 00 / 1/ 1353500
Start - 0 / 0Start - 0 / 0
Stop - 250 / 250Stop - 250 / 250
NOTE:NOTE: Depress the F2 button (ResDepress the F2 button (Reset) to return the selected fet) to return the selected function back to its default unction back to its default setting.setting.
To Next Page
Loading...
