9C-99C-9TX / TXH / TXB 180S - 400L (Rev. 4/23/07)TX / TXH / TXB 180S - 400L (Rev. 4/23/07)
The second group shows the shift lever position and some other less used but nevertheless quite relevantThe second group shows the shift lever position and some other less used but nevertheless quite relevant
values (see below).values (see below).
The third display accessed with the ’M’ button (F3) isn’t actually a group of screens but is used to informThe third display accessed with the ’M’ button (F3) isn’t actually a group of screens but is used to inform
you about any current or previously active errorsyou about any current or previously active errors. . The display normally shows ’ – – ’ to indicThe display normally shows ’ – – ’ to indicate there areate there are
no faults, but if one or more faults are (or have been) detected, the most severe one is shown until youno faults, but if one or more faults are (or have been) detected, the most severe one is shown until you
press the ’S’ switch (F4). press the ’S’ switch (F4). Doing so reveals the next error untDoing so reveals the next error until no more errors are present, at wil no more errors are present, at which timehich time
again the ’ – – ’ sign is shown.again the ’ – – ’ sign is shown.
To Next Page
Loading...
