TBB APOLLO MAXX Series - Parameter Configuration: Output and ACin; Output Parameters; AC Input Parameters

Apollo Maxx User Manual
19
01
Output frequency
50~60Hz
Step:10Hz
Default:50Hz
(only in standby mode)
02
Parallel mode
0-Stand-alone
1-Parallel
2-Three-Phase
Default:0
(only in standby mode)
03
Parallel phase
1-Phase-U (L1)
2-Phase-V (L2)
3-Phase-W (L3)
Default:1
(only in standby mode and
parallel system)
04
Synchronize parallel parameters
1 (Press <ENTER> to trigger
the effect once)
Default:0
05
Fault unlock
1 (Press <ENTER> to trigger
the effect once)
Default:0
06
Fan dedusting
1 (Press <ENTER> to trigger
the effect once)
Default:0
07
Parallel address
1~Max（U: 3 / V: 2 / W: 2）
Default:1
08
Independent mode selection
at battery bank of parallel
system
0-Disable
1-Enable
Default:0
ACin Parameter
10
AC in source selection
0-Grid
1-Generator
Default:0
(only in standby mode)
11
Power assist current
0~Max(Rate AC input Current)
Step:1A
Default: Max
12
AC in source priority
0-AC First
1-BATT First
2-Time Ctrl
3-Ubat Ctrl/ SOC Ctrl
4-AC IN backup
Default:0