TC Electronic Alter Ego Delay - Changing the Battery; Technical Specifications; Getting Support

Getting support
Alter Ego Delay English Manual Version 1.0 17
Changing the battery
If you need to change the battery of your pedal,
proceed as follows:
– Unscrew the thumb-screw on the back of the
pedal and detach the back-plate.
– Unmount the old battery and attach the new
battery to the battery clip making sure the po-
larity is correct.
– Remount the back-plate.
Notes regarding batteries
– Batteries must never be heated, taken apart or
thrown into fire or water.
– Only rechargeable batteries can be recharged.
– Remove the battery when the pedal is not
being used for a longer period of time to save
battery life.
– Dispose batteries according to local laws and
regulations.
Technical Specifications
– Delay Types: 9 + TonePrint + Looper
– Max Delay length: 7seconds
– Max Loop length: Mono: 40seconds
– Stereo: 20seconds
– Mono/Stereo: Auto-sensing – automatic
Mono or True Stereo mode depending on the
connections used
– Bypass mode:
True Bypass (Buffered Bypass optional)
– Signal Circuitry: Analog Dry-Through
– Dimensions (W x D x H):
72 x 122 x 50mm / 2.8 x 4.8 x 2.0”
– Input Connector Types:
2 Standard ¼” jack – mono/TS
– Output Connector Types:
2 Standard ¼” jack – mono/TS
– Power Input: Standard 9V DC, centre nega-
tive >100mA (not supplied)
– Battery option: Standard 9V (not supplied)
– Input Impedance: 1 MΩ
– Output Impedance: 100 Ω
Getting support
If you still have questions about the product af-
ter reading this manual, please get in touch with
TC Support:
http://tcelectronic.com/support/