Need help?Do you have a question about the TC Electronic BH550 and is the answer not in the manual?
General| Number of Channels | 1 |
|---|---|
| Speaker Outputs | 2 x Speakon |
| Input Impedance | 1 MΩ |
| Cabinet Simulation | No |
| Effects Loop | Yes |
| DI Output | Yes |
| Impedance | 4Ω or 8Ω |
| EQ | 4-band |
| Inputs | 1 x 1/4" |
| Outputs | 1 x XLR |
| Tone Controls | Bass, Treble |
| Power Output | 550 Watts |
| Weight | 9.3 lbs (4.2 kg) |
Contact TC Support for product questions after reading the manual, via website.
Steps for connecting the amp, cabinets, and bass, and adjusting initial settings.
Sets input gain to highest level without overloading. Peak LED indicates input overload.
Addresses multiple frequencies intelligently for tone shaping and contouring with ease of use.
Sets the overall output volume of the amp and controls the headphone output level.
Connects to mains supply (100-240V). Ground pin must be connected to avoid voltage differences.
speakON connector for speaker cabinets. Requires speakON cables. Minimum load of 4 Ohms.
XLR output for connecting to PA systems or recording devices. Signal can be pre/post EQ.
Steps to take if the amplifier enters protection mode, including checking ventilation and cables.
To Next Page
