TC Electronic C300 User Manual

13
CABLES
Type 3
Connecting to balanced equipment.
When connecting to C300 outputs to downstream devices with balanced inputs you MUST use
mono/unbalanced plugs in the C300 outputs.
Warning!
Do NOT use balanced cables from the C300
outputs. This may introduce unwanted hum or
noise.
It is a common problem that you will
loose 6dB of signal when connecting
unbalanced equipment to balanced.
This is not the case with the C300 if
you use the cables as described in this
section.

TC Electronic C300 Specifications

Operating Environment

operating temperature	32° F to 122° F (0° C to 50° C)
storage temperature	-22° F to 167° F (-30° C to 70° C)
humidity	Max. 90 % non-condensing

Power

mains voltage	100 to 240 VAC, 50 to 60 Hz (auto-select)
power consumption	<15 W

Digital Input and Output

sample rates	48 kHz. (44.1 kHz only @ Digital Input)
processing delay	0.08 ms @ 48 kHz
frequency response DIO	DC to 23.9 kHz ± 0.01 dB @ 48 kHz

Analog Inputs

impedance, bal / unbal	20 kOhm / 11 kOhm
max. input level @ 0 dBFS	+21 dBu
A to D delay	0.9 ms @ 48 kHz

Analog Outputs

impedance	35 Ohm
max. output level	+21 dBu
D to A delay	0.58 ms @ 48 kHz

Weight and Dimensions

dimensions	19" x 1.75" x 4.2" (483 x 44 x 105.6 mm)
weight	3.3 lb. (1.5 kg)