TC Electronic NOVA System - Typical Setup Configurations; Basic Setup with a Single Amp

10
TYPICAL SETUPS
Basic setup
This is a typical basic setup combining NOVA System
with one combo amp (or two for stereo) running a clean
channel. All effects and overdrive/distortion are
generated by NOVA System. A G-Switch (optional) is
connected and the NOVA System is then automatically in
stomp mode. Presets are then recalled using the G-
Switch.
Connections
• Connect your guitar to the NOVA System’s Drive
input
• Connect Left output to a guitar amp running a clean
channel
• Connect the right output to a second guitar amp for
stereo (optional)
• Connect G-Switch (optional) to the pedal input
pedal input
Basic settings
• Set input sensitivity via the Levels menu
W
ith a G-Switch connected:
• Activate/deactivate effect blocks pressing the effects
switches
• Change presets using G-Switch
W
ith no G-Switch connected:
• Select the Footswitch parameter in the Utility menu
and select Pedal (stomp) or Preset mode
• Select preset - if in preset mode
• Activate/deactivate effect blocks pressing the effects
switches