display, and the name of the target note is displayed at the bottom of the display.
If the string you are tuning is too low, LEDs to the left of the center column will light up. If the string is too high, LEDs
to the right of the center column will light up.
Tune the string until the middle column and the middle row of green LEDs lights up. This means you are “on target”.
Strobe mode
1. Red LEDs to the left (pitch too low) or to the right (pitch to high) of the center LED column
2. Rotating segments in the display. The closer the detected frequency is to the target frequency, the slower the
rotation.
Tune the string until the rotating pattern has come to a stop and only the middle column of green LED lights up.
Polyphonic tuning
As you know by now, POLYTUNE 3 is a polyphonic tuner. You can strum your instrument, and POLYTUNE 3 will
analyze and display the tuning of all strings.
So how do you activate polyphonic tuning mode?
You don’t – it just works. Strum, tune, rock on!
Of course, only the strings that are actually present and played will be shown in the display. So if you tune a four
string bass, only four LED columns will light up.
To Next Page
Loading...
Need help?
General
