TC Electronic POLYTUNE 3 User Manual

tuning modes, including polyphonic, chromatic, strobe and a variety of altered tunings; adding an onboard
BONAFIDE BUFFER to preserve your tone over long cable runs and pedal board signal paths; and upgrading the
LED display for even higher tuning accuracy.
Enter POLYTUNE 3.
Unpacking
Your TC ELECTRONIC effect pedal box should contain the following items:
Your TC ELECTRONIC effect pedal
1 TC ELECTRONIC sticker
1 Quick Start Guide for quick information about the pedal’s controls
Inspect all items for signs of transit damage. In the unlikely event of transit damage, inform the carrier and supplier.
If damage has occurred, keep all packaging, as it can be used as evidence of excessive handling force.
Setting up
Connect a 9 V power supply with the following symbol to the DC input socket of your TC ELECTRONIC effect pedal.
This product does not come with a power supply. We recommend using TC ELECTRONIC’s PowerPlug 9 (sold
separately).
You can also power POLYTUNE 3 using a standard 9V battery (not included), but if you intend to power
additional pedals using the power out jack, you need to use a power supply. Plug the power supply into a power
outlet.
Plug the power supply into a power outlet.
Connect your instrument to the in jack on the right side of the pedal using a 1⁄4″ jack cable.
Connect the out jack on the left side of the pedal to your amplifier using a 1⁄4″ jack cable.
If you have another 9 V guitar pedal that you want to power, connect it to the power out socket on the rear of the
pedal.
Get ready for a new tuning experience!
Tuning your instrument with POLYTUNE 3 is fast and intuitive. If you don’t feel like reading the manual, just strum
your instrument and watch the display. We think you’ll like what you see.

TC Electronic POLYTUNE 3 Specifications

General

Best uses	Guitar
Product type	-
Product color	White
Output impedance	100 Ω