KMS-2/Exia Transmitter
Installation and Operating Manual
ATEX
Rev D 20/09/2018 KMS-2/Exia IOM Page 1 of 13
Symbols Used
The following symbols are used in these operating instructions:
Warning:
If ignored injury or damage to property can occur.
Danger:
If ignored serious injury or damage to property can occur.
Caution:
Failing to comply with these instructions can lead to malfunction
of or damage to the Level Transmitter.
Ex Applications
Instructions which must be complied with when the unit is used in
potentially explosive environments and to meet the requirements of the
EU type examination certificate.
Information
Facts and information concerning proper operation of the
KMS-2 Level Transmitters
Instructions for electrical installation
Information on proper electrical installation.
Safety information
Read these instructions before installation and putting into operation.
Installation commissioning and maintenance should only be carried out by suitably
qualified personnel in conjunction with these instructions.
Comply with the relevant safety regulations when using the equipment.
The transmitter must not be modified as this will invalidate the warranty and or the product certification.
Measures must be taken to prevent risks to persons and property in the event of a defect.
Do not operate the Level Transmitters in the immediate vicinity of strong electromagnetic fields (minimum
distance: 1 m) as this may give rise to incorrect readings.
Comply with the maximum current and voltage ratings as stated in the technical data section.
For intrinsically safe applications installation of this unit must be in compliance with the applicable
National requirements i.e. EN60079-14.
To Next Page
Loading...
