Need help?Do you have a question about the TC-Helicon Voicetone Double and is the answer not in the manual?
General| Technology | Digital Signal Processing |
|---|---|
| Power Supply | 9V DC |
| Weight | 1.5 lbs |
| Pitch Correction | Yes |
| Bypass | True Bypass |
| Effects | Doubling |
| Inputs | XLR |
| Outputs | XLR |
| Harmony Voices | 2 |
Introduces the TC-Helicon VoiceTone Double for performance singers.
Details TC-Helicon's philosophy and commitment to vocalists.
Controls microphone pre-amplifier gain for dynamic or condenser mics.
Indicates microphone input level; green/orange is good, red indicates clipping.
Adjusts pitch and time humanization for patches.
Controls mix levels of Overdub versus µMod effects.
Shows the current bank and patch selection.
Indicates phantom power status (on/off).
Cycles through the 10 available banks.
Indicates stereo output status; off means mono.
Toggles between A/B settings; holding stores them.
Toggles the doubling effect on and off.
Connection point for the microphone.
Connects mono or left stereo output to a sound system.
Connects mono or right stereo output to a sound system.
Input connector for the power supply.
Details how to enable and use phantom power for condenser microphones.
Explains the standard live connection for VoiceTone Double.
Explains how to configure the device for stereo operation.
Details setup for mono wet/dry mix control by a sound engineer.
Describes setup for 100% wet stereo output for mixing.
Describes the four controls for modifying current patch settings.
Explains how to save custom presets and their settings.
Provides rough descriptions for each preset.
Troubleshooting steps for no audio output from the device.
Steps to resolve issues where effects are not audible.
Diagnosing why edit knobs do not produce audible changes.
Troubleshooting steps for distorted audio output.
Instructions for resetting the device to factory presets.
To Next Page