9
Connections and Setup
Switching On
Follow the instructions on this page on how to switch on your TV set and
the remote control before going on to following pages describing how to
use the channel set-up procedure.
1. Insert two AAA batteries in the remote control.
Precautions on using batteries:
- Only use the battery types specied.
- Make sure you use the correct polarity.
- Do not mix new and used batteries.
- Do not use rechargeable batteries.
- Do not expose batteries to excessive heat such as sunshine, re or
the like, throw them in a re, recharge them or try to open them, as
this could cause them to leak or explode.
- Remove the batteries from the remote control if you are not using it
for a long period of time.
- Attention should be drawn to the environmental aspects of battery
disposal.
2. Connect the power cable FIRST to the television, THEN to a mains
socket. (
Note:
If the power cable is connected to the television, please
only connect the power cable to the mains socket.
)
Your TV set should only be connected to an AC supply. It must not be
connected to a DC supply. If the plug is detached from the cable, do
not, under any circumstances, connect it to a mains socket, as there is
a risk of electric shock.
Note:
The gures are for representation only, the location of power
socket of the television might dier depending on the model.
3. Connect an outside aerial to the
ANTENNA IN
socket at the back of
the TV set.
The aerial socket (75 OHM - VHF / UHF / cable) can be used for
connecting an external aerial or other equipment tted.
4. When powered on, the TV will be turned on directly or be in standby
mode.
If the power indicator lights up, the TV set is in standby mode. Press
the
button on the remote control or on the TV set to turn on the TV.
Switching O
To put the TV set into standby mode, press the
button on the
remote control. The TV set remains powered up, but with low energy
consumption.
To switch o the TV set, unplug the mains socket from the mains
outlet.
To Next Page
Loading...
