TCL Inverter TAC-18CHSD/XAB1I - First-Time Installation Procedures

TCL Air Conditioner Service Manual
9.2 Installation for the first time
Indoor unit
 Install the indoor unit level on a strong wall that
is not subject to vibrations
 The inlet and outlet ports should not be
obstructed: the air should be able to blow all over
the room.
 Do not install the unit near a source of heat,
steam, or flammable gas.
 Install the unit near an electric socket or private
circuit.
 Do not install the unit where it will be exposed
to direct sunlight.
 Install the unit where connection between indoor
and outdoor unit is as easy as possible.
 Install the unit where it is easy to drain the
condensed water.
 Check the machine operation regularly and
leave the necessary spaces as shown in the
picture.
 Install the indoor unit where the filter can be
easily accessible.
OUTDOOR UNIT
 Do not install the outdoor unit near sources of
heat, steam or flammable gas.

Do not install the unit in too windy or dusty
places.
 Do not install th
e unit where people often
pass. Select a place where the air discharge
and operating sound level will not disturb the
neighbours.

Avoid installing the unit where it will be
exposed to direct sunlight (other wise use a
protection, if necessary, that should not
interfere with the air flow).
 Leave the spaces as shown in the picture for
 The air to circulate freely.
 Install the outdoor unit in a safe and solid place.

If the outdoor unit is subject to vibration, place
rubber gaskets onto the feet of the unit.
 Install the indoor unit in the room to be air
conditioning, avoiding to installation in
corridors or communal areas.
Minimum space to be left (mm) showing in the
picture.
300mm
5
0
0
m
m
2
0
0
0
m
m
3
00
m
m
5
0
0
m
m
condensed water drain pipe
150mm
150mm
1
5
0
m
m
Sleeve
insulating covering
electrica l cable
Mounting plate
water dra in pipe
34