TCM FB18-7 - Replacing light bulbs

9. ELECTRIC WIRING
- 154 -
■ Replacing light bulbs
If you want to remove a bulb, push it into the
reector and then turn to the left.
If you want to install a new bulb, push it into the
reector and then turn to the right.
(1) Head light and work light
① Remove the screw securing the rim and housing,
and remove the rim, lens, and gasket.
② Remove the bulb from the reector and install a
new bulb.
1. Use caution not to get burnt because the surface of a hot soon after it is turned off.
 2. Usecautionnottocontaminatethebulbandreectorsurfaces.
③ With the gasket, install the lens and reector.
(2) Rear and front combination lights
① Remove the screws securing the lens and body,
and separate the lens from the body.
② Remove the the burned-out bulb you want to
replace and install a new bulb.
③ Reassemble the lens and body with the screws.
REFLECTOR
SCREW
40W‑48V
GASKET
LENS
RIM
Fig. 9.5 Head Light (Work Light)
BACK-UP LIGHT
10W-48V
LENS
SCREW
STOP/
TAIL LIGHT
25W/10W-48V
TURN SIGNAL
LIGHT
25W-48V
BODY
Fig. 9.6 Rear Combination Light
SCREW
TURN SIGNAL LIGHT
25W-48V
SIDE MARKER LIGHT
10W-48V
BODY
LENS
Fig. 9.7 Front Combination Light