TCNet Boiler Controller - Digital Input Configuration; Analog Input Configuration; Device Testing Procedures; Factory Default Restoration

TCNet Boiler Controller
User and Service Manual
25
Digital Inputs
IN0: OFF
IN4:OFF
The input signals of the
controller.
OFF : No signal / Open
ON: Signal / Close
IN1: OFF
IN5: OFF
IN2: OFF
IN6: OFF
IN3: OFF
IN7: OFF
Analog Inputs
T3 (boiler temp. Sensor)
LM (Lambda sensor)*
The measured values of the
Analog-to-digital converter of
the controller
T1 (Util. Water temp. Sensor)
PC (Photocell)*
T2 (Weather temp. Sensor)
TC (Flue temp. Sensor)
(*) Lambda sensor and photocell may not be implemented on your system.
Test Devices
Warning! This menu is only for testing the outputs of the boiler for a short time. Leaving
the boiler in Test Devices menu may cause dangerous conditions.
IGN
FAN1
Select the device with
navigation keys to test.
+ adjust key: RUN
_ adjust key: STOP
PUMPH
FAN2
PUMPU
FAN3
AUGER
CLEAN
REFILL
Factory Defaults
Restores all parameters to the Factory defaults.
Error Log
Controller stores the last five errors.
Record format is DD/MM/YYYY HH:MM – Error code