WARRANTY 1.2
1) Within the limits set forth in this warranty, the undersigned manufacturer undertakes to repair any and all
manufacturing defects that occur during the warranty period.
2) The warranty becomes void if the purchaser does not properly follow all the instructions described in these
"Installation Instructions".
3) In order to take advantage of the right of warranty, the purchaser, upon occurrence of the fault, shall timely notify
it to the manufacturer and allow the same, if necessary, to carry out the related inspections and repairs.
4) The purchaser shall bear the transport charges to send the defective part covered by warranty to the
manufacturer and then back to the purchaser, in order to allow the repair or replacement of the same. The
warranty obligation, as provided in this clause, shall be deemed fulfilled with the delivery to the purchaser of the
part properly repaired or replaced.
5) During the warranty period referred to in clause 1), labor costs for the repair will be borne by the manufacturer. If
repairs or replacements have to be made at the customer's premises, the costs of travel and lodge of the
personnel shall be borne by the purchaser.
6) The guarantee does not include breaks caused by wrong operation, incompetence, accident or otherwise
attributable to the user, both due to himself and to third parties, or when the user has made modifications or
repairs without the written consent of the manufacturer, regardless of the connection between such changes or
repairs and the detected defects.
7) It is expressly agreed that the manufacturer will be relieved from any responsibility for any damages caused to
the purchaser by a loss of or decreased production, resulting from manufacturing faults or defects.
CE MARKING / RATING PLATE 1.3
The CE marking certifies the conformity of the equipment with the essential safety and health requirements set forth
by the European Directives mentioned on the Declaration of CE Conformity.
The rating plate consists of a silver polyester adhesive label with black print, having the following dimensions: L= 102
mm - H= 50 mm (FIG. 1). It is applied externally on one side or on the front panel. The rating plate bears the logo, CE
marking, type, serial number, main rating data, and power supply voltages.
FIG. 1 – CE marking and rating plate
IMPORTANCE OF THE MANUAL 1.4
This technical installation manual was drawn in order to assure an easy and correct understanding of the covered
contents by the operators entrusted with the use and maintenance of the involved equipment.
If, despite the attention paid by the manufacturer in drawing up this document, the above mentioned operators should
have any doubts concerning the understanding of the document, in order to avoid misinterpretations that may
jeopardize safety, they are kindly requested to promptly ask for correct explanations and further information to the
manufacturer.
Before using the involved equipment, the authorized operators must mandatory read and understand this technical
manual of "Instructions for installation" in all its parts and strictly follow the instructions herein described in order to
assure one's own safety and that of others, attain better equipment performance, and assure maximum efficiency and
duration of all machine components.
BEFORE USING THE EQUIPMENT, THE AUTHORIZED OPERATORS MUST MANDATORY
READ AND UNDERSTAND THIS MANUAL IN ALL ITS PARTS.
To Next Page
Loading...
