TDE MACNO BDF DIGITAL OPDE SD 22 - Electric Connections

20
MP01200E00 V_1.0
SOME PARTS OF THE CONVERTER METAL CASE MAY EXCEED 70 °C DURING OPERATION. THEY
ARE MARKED BY THE SPECIAL LABEL "CAUTION, HOT SURFACE" SHOWN HERE ON THE SIDE.
ELECTRIC CONNECTIONS 7.2
ALL THE FOLLOWING OPERATIONS ARE NECESSARY TO PREPARE THE ELECTRIC
CONNECTION OF OPDE DC-DC CONVERTER.
DC INPUT VOLTAGE AND DC OUTPUT VOLTAGE SHALL SATISFY THE TECHNICAL FEATURES
SHOWN IN THE TAB. 24A, 24B, 24C, 24D AND MEET THE REQUIREMENTS SET FORTH BY THE
REGULATIONS IN FORCE IN THE COUNTRY OF USE THEREOF.
ANY TYPE OF ELECTRICAL EQUIPMENT (CABLES, OUTLETS, PLUGS, ETC.) USED FOR THE
CONNECTION MUST BE SUITABLE FOR USE, "CE" MARKED - IF SUBJECT TO THE LOW VOLTAGE
DIRECTIVE 2006/95/EC, AND COMPLY WITH THE REQUIREMENTS SET FORTH BY THE
APPLICABLE LAW IN FORCE IN THE COUNTRY OF USE OF THE OPDE DC-DC CONVERTER.
THE MANUFACTURER DENIES ALL LIABILITY FOR FAULTS OR MALFUNCTIONS OF THE OPDE
DC-DC CONVERTER DUE TO SUDDEN VOLTAGE CHANGES EXCEEDING THE TOLERANCES SET
BY THE POWER DISTRIBUTION COMPANY (VOLTAGE ± 10%).
FAILURE TO FOLLOW THE ABOVE PRECAUTIONS MAY RESULT IN PERMANENT DAMAGES TO
THE ELECTRICAL EQUIPMENT OF THE OPDE DC-DC CONVERTER, AND IN THE FOLLOWING
VOIDNESS OF THE WARRANTY.
THE MANUFACTURER DENIES ALL LIABILITY FOR ANY DAMAGES TO PEOPLE, ANIMALS AND/OR
PROPERTY CAUSED BY THE INCORRECT ELECTRICAL CONNECTION OF THE OPDE DC-DC
CONVERTER AND ITS COMPONENTS.