2
OPERATION MANUAL
1.INSPECTION
-After unpacking the pump, please check if it has been damaged during transport. If so, please
contact TDRFORCE online services at the first time.
2.INSTALLATION
-Make sure that the main voltage corresponds to the voltage specified on the motor rating plate.
-Place the pump as near as possible to the suction tank.
-Do not submit the pump body to mechanical stress.
-The pump must be sheltered from weather ( sun- rain- wind- snow- chill).
-The motor must be absolutely grounded before any other operation.
-The suction pipe diameter must always be bigger than the suction port. Always fit a foot valve
with strainer on the suction pipe. Both suction and delivery pipe must be well fastened.
3.STARTING THE PUMP
-Check that the pump does not run out of the operating data.
-For the proper functioning of the system,allow a 20-minute stop for every 20 minutes of
dispensing. Operation of the pump without dispensing is only admitted for periods of no longer
than 3 minutes.
-The pump could be only used in fresh water & urea circulating and transferring.
-We recommend that the pump remains switched off whenever the system is not in use.
4.MAINTENANCE
-The dispensing system was designed and built to require a minimal amount of maintenance.
-Before carrying out any maintenance work, disconnect the dispensing system from any electrical
and hydraulic power source.
-During maintenance,the use of personal protective equipment (PPE)is compulsory.
-Whenever there is risk of frost, empty the plumb system.
-Check that the pipe connections are not loose to prevent any leaks.
-Check and keep the filter installed on the suction line clean. Check the pump body and keep it
clean and free of any impurities.
-Check that the electrical supply cables are in good condition.
To Next Page
Loading...
