Need help?Do you have a question about the TE LDM-1000 and is the answer not in the manual?
General| Input Type | Thermocouple, RTD |
|---|---|
| Output Type | Relay, SSR Drive |
| Control Mode | PID, On/Off |
| Display | Dual LED |
| Power Supply | 100-240 VAC |
| Operating Temperature | 0-50°C |
Configure the 18-30 VDC or 10-18 VDC supply range using the JP1 jumper.
Details DIP switch functions for offset, bandwidth, gain, oscillator frequency, sync, and output voltage.
Guide to setting the transducer excitation frequency (2.5, 5, or 10 kHz) via DIP switches.
Setting Master (INT) or Slave (EXT) oscillator modes for synchronized operation of multiple units.
Information on the oscillator's maximum drive current (25mA RMS) and transducer impedance requirements.
How to calculate and set amplifier gain using DIP switches based on transducer sensitivity.
To Next Page