Teac A-3340 - DISASSEMBLY PROCEDURES; REMOVING REAR PANEL AND WOODEN SIDES; REMOVING THE BOTTOM PLATE

REMOVING THE REAR PANEL AND WOODEN SIDES
1. Loosen the four screws on each
wooden side.
2. Remove the six screws holding
the rear panel.
3. Lift off rear panel.
4, Remove the eight screws in the
two wooden sides.
5. Remove the wooden sides.
D-0379
Fig. 4-1 Removing Wooden Sides
REMOVING THE BOTTOM PLATE
1. Place the unit upside down.
2. Remove the three screws in the
bottom plate.
3. Lift off bottom plate.
0-0380
Fig. 4-2 Removing Rear Panel and Bottom Plate
*A11 amplifier checks and adjustments can be made from the bottom
with the plate removed. ;
‘CAUTION
These adjustments should be performed by experienced technicians,
and then only when going through the complete test and check pro-
cedures on the unit which is being tested.