Need help?Do you have a question about the Teac A-3300 and is the answer not in the manual?
General| Track System | 4-track, 2-channel, stereo/monaural system |
|---|---|
| Signal to Noise Ratio | 58dB |
| Total Harmonic Distortion | 1.5% |
| Motor Type | AC Synchronous |
| Type | Reel to Reel Tape Deck |
| Tape Speed | 3.75 & 7.5 ips (inches per second) |
| Wow and Flutter | 0.08% (7.5 ips) |
| Frequency Response | 30Hz to 28kHz (7 1/2 ips) |
| Heads | 1 x erase, 1 x record, 1 x playback |
| Reel Size | 7 inch |
| Inputs | Microphone, Line |
| Outputs | Line |
Aligning the erase head pole relative to the tape width.
Aligning the record head pole relative to the tape width.
Aligning the playback head pole relative to the tape.
Procedure to measure and adjust pinch roller pressure using a spring scale.
Measuring and adjusting take-up and back tension torques with resistors.
Procedure for checking and adjusting brake torque using a spring scale.
Adjusting playback head azimuth for optimal signal using a level meter.
Setting the nominal output signal level using output controls and VRs.
Adjusting the bias trap circuit to minimize bias signal leakage.
Adjusting bias levels for optimal recording performance.
To Next Page
