Teac AG-H500 - FM Mono Distortion Adjustment; FM;AM Auto Stop Level Adjustment; AM Stereo Separation Adjustment

3. FM MONO DISTORTION ADJUSTMENT
DC VOLT METER ::---:-- Connect to TP11(-), TP12(+) Through the choke coll (100/H)
Signal Generator:------- Connect to FM ANT Jack (FM IN) through the dummy.
Distortion Meter -------- Connect to the output
[EUR]
Adjust for Adjustment
Frequency Adjust for Adjustment
83.1MHz DC Voltmeter 0V T101
== DISTORTION
ANALYSER
T102
4. FM/AM AUTO STOP LEVEL ADJUSTMENT
FM SIGNAL GENERATOR - ++ sees sere terre rete eee Connec to FM ANT Jack(FM IN)through the dummy
AM SIGNAL GENERATOR: : +++ +++ r err t reer eres Connect to AM ANT, Coil through the Loop antenna
[EUR/CSA/TW]
BAND | STEP | SIGNAL GENERATOR Adjust for
ia 100.1MHz 30dB [TUNED] Display OFF VR11
FM
ae 100.1MHz 30dB [TUNED | Display ON VR11
990kHz 80dB | TUNED | Display OFF VR21
[TUNED | Display ON
990kHz 80dB
SIGNAL GENERATOR Adjust for
Display OFF
Display ON
Display OFF
Display ON
Adjustment
83.1MHz 30dB VR11
83.1MHz 30dB VR11
990kHz 80dB VR21
990kHz 80dB VR21
5. AM STEREO SEPARATION [DM]
AC _EVM_ OSCILLOSCOPE
Pilot Signal Adjust for
Different of R and L
NOTE : In case of adjusting the stereo separation, of
input is L(or R) channel, R(or L) channel! mst
be maximum
OUTPUT
terminal
+O
C)-o
5