To Next PageTo Next Page
Need help?Do you have a question about the Teac AG-V8520 and is the answer not in the manual?
General| Total Harmonic Distortion | 0.09% |
|---|---|
| Tuning Range | FM, MW |
| Input Sensitivity (MM) | 2.5mV |
| Signal to Noise Ratio (MM) | 75dB |
| Signal-to-Noise Ratio (MM phono) | 75dB |
| Speaker Load Impedance | 8 ohms |
Describes warnings, lightning flash symbol, and exclamation point symbol for user safety.
Instructions to record the unit's model and serial number for future reference.
Covers reading instructions, warnings, cleaning, attachments, water, accessories, and power cord handling.
Addresses antenna grounding, lightning, power lines, overloading, liquid entry, and installation.
Details when to seek qualified service and replacement parts.
Recommendations for unit placement, ventilation, and avoiding environmental hazards.
Instructions for voltage selector use and proper power plug handling.
Information on FCC rules for US operation and Canadian power cord safety.
Illustrates how to connect various audio and video components to the receiver.
Details on connecting speakers to terminals and using AC outlets.
Explanation of the VIDEO 2 INPUT jacks for video sources.
Guidance on connecting indoor and outdoor FM antennas for optimal reception.
Instructions for connecting indoor loop and outdoor AM antennas.
Details on connecting speakers and recommended impedance.
Information on connecting the power cord and using the switched outlets.
Identifies and describes the function of each control on the front panel.
Explains the meaning of various indicators and example displays.
Details all buttons on the remote control unit and their corresponding functions.
Explains the various indicators shown on the remote control's display.
Tips for pointing the remote and notes on potential interference.
Guide to installing batteries and important safety precautions.
Describes the back-up memory function for preserving settings.
How to set the receiver to automatically turn off after a set period.
Steps for turning on the unit and selecting an audio/video source.
Explanation of Power, Speaker, Line Straight, Tone, Balance, Loudness, and Muting controls.
Procedure for automatically scanning and tuning radio stations.
Step-by-step guide for manually tuning radio frequencies.
Using the remote's numeric keys to directly tune to a specific frequency.
How the receiver automatically scans and stores radio stations.
Steps for manually assigning stations to preset memory channels.
Using memory scan to find stations and recalling preset channels.
Instructions for listening to music from turntables and CD players.
How to operate the tape deck for playback.
Guidance on recording sources and monitoring tape playback.
Connecting and playing back video from components like VCRs or camcorders.
Instructions for dubbing video tapes and using the S.A.V.E. feature for audio replacement.
Overview of the different surround sound modes offered by the receiver.
Detailed explanation of Dolby Pro Logic and Dolby 3 Stereo surround effects.
Description of Hall and Theater surround modes for enhanced listening.
How to disable surround effects for standard stereo playback.
Options for center speaker output: Normal, Wide, and Phantom.
Recommendations for speaker placement to achieve the best surround effect.
Adjusting delay times for rear speakers based on surround mode.
Steps to balance speaker volumes and adjust delay for Dolby Pro Logic.
Steps to balance speaker volumes for Dolby 3 Stereo playback.
Adjusting speaker levels and delay times for Hall/Theater modes.
Instructions for resetting the system and the consequences of a reset.
How the receiver's remote can operate other TEAC devices with remote sensors.
Using the remote for CD sync recording and operating Tape I/II mechanisms.
Details on using remote buttons for CD playback functions like Skip and Pause.
Troubleshooting steps for audio and radio reception problems.
Solutions for surround sound problems and remote control failures.
Detailed technical specifications for amplifier and tuner performance.
Specifications for video section, power requirements, dimensions, and included accessories.
List of TEAC corporations and their contact details by region.
