Teac CD-RW890 User Manual

10
1
Press the OPEN/CLOSE (L) button.
The disc tray is opened.
2
Place a disc on the tray with the disc label side up.
Never place more than one disc on the tray. <
The disc must be placed in the center of the disc tray. If the disc is <
not correctly loaded, it may not be possible to open the tray again
once it has closed, so you should ensure the disc is always centered
on the tray.
Do not force the tray by hand during opening and closing <
operations.
3
Press the OPEN/CLOSE (L) button to close the tray.
The tray is closed. Take care that you do not catch your fingers in
the tray.
It takes a few seconds for the unit to load the disc. No buttons will <
work during loading. Wait until the total number of the tracks and
the total play time of the disc are displayed.
Turning on the power
Press the POWER button to turn on the unit.
Using Headphones
For private listening, first reduce the volume level to minimum.
Then insert the plug from your headphones into the PHONES jack,
and adjust the volume by turning the LEVEL knob.
When turning the power on/off, unplug the headphones. Failure to
observe this precaution may cause a noise to be produced.
Basic Operation Basics of Playback
CD-RW890EvAunlocked.pdf10 10/09/0817:17

Teac CD-RW890 Specifications

Power

operation voltage (US)	120V AC, 60Hz
operation voltage (EUR)	230V AC, 50Hz

Audio Interfaces

audio input	x 1
audio output	x 1
digital audio input	x 1 (Optical)

Weight and Dimensions

width	435 mm
height	100 mm
depth	295 mm
weight	4.5 kg