35
ENGLISH
4. Controls and Functions
With S1 open (jumper not set) the TEAC CD-W54E ist set to sin-
gle or slave mode by setting the jumpers S2 and S3. The set mode
is irrespective of the CSEL signal. Master/slave mode is determined
by CSEL if S1 is shorted (jumper set). In this case S2 and S3 are
irrespective for setting the mode.
Note:
When setting modes using these straps, be sure to switch off the
CD-RW drive before doing so.
Remark: X: Strap shorted
–: Strap open
S1 S2 S3 Remarks
X––
CSEL. Master or Slave drive is set by using
CSEL terminal. (DASP signal is used to
recognize slave drive. If slave is absent, the
shadow register is used.)
–X–Slave
––X
Master (DASP signal is used to recognize
slave drive. If slave is absent, the shadow
register is used.).
To Next Page
Loading...
