Teac LE43A718UHD - Connecting to your mobile device via WiFi

26

If the selected network is protected with a password, please enter the correct key by using the virtual
keyboard. You can use this keyboard via the directional buttons and the OK button on the remote
control.
Wait until the IP address is shown on the screen. This means that the connection is now established.
To disconnect from a wireless network, highlight Network Type and press Left or Right buttons to set
as Disabled.
Highlight Internet Speed Test and press the OK button to check your internet connection speed.
Highlight Advanced Settings and press the OK button to open the advanced setting menu. Use
directional and numeric buttons to set. Press the OK button to save settings when complete.
Other Information
The status of the connection will be displayed as Connected or Not Connected and the current IP
address, if a connection is established.
Connecting to your mobile device via WiFi
If your mobile device has Wi-Fi feature, you can connect it to your TV via a router, in order to
access the content in your device. For this, your mobile device must have an appropriate sharing
software.
Connect to your router following the steps stated above in the Wireless Connectivity
section.
Afterwards, engage your mobile device with the router and then activate the sharing software
on your mobile device. Then, select files that you want to share with your TV.
If the connection is established correctly, you will be able to access the shared files from your
mobile device via the Media Browser of your TV.
Enter the Media Browser menu and the playback device selection OSD will be displayed.
Select your mobile device and press the OK button to continue.
If available, you can download a virtual remote control application from the server of your
mobile device application provider.
Note: This feature may not be supported on all mobile devices.
Wireless Display
Wireless Display is a standard for streaming video and sound content by the Wi-Fi Alliance. This
feature provides the ability to use your TV as wireless display device.
Using with mobile devices
There are different standards which enable sharing of screens including graphical, video and audio
content between your mobile device and TV.
1. Plug the wireless USB dongle to TV first, if the TV doesn’t have internal WiFi feature.
2. Press the Source button on the remote and switch to Wireless Display source.
3. A screen appears stating that the TV is ready for connection.
4. Open the sharing application on your mobile device. These applications are named differently
for each brand, please refer to the instruction manual of your mobile device for detailed
information.
5. Scan for devices. After you select your TV and connect, the screen of your device will be
displayed on your TV.
Note: This feature can be used only if the mobile device supports this feature. Scanning and connecting
processes differ according to the programme you use. Android based mobile devices should have the software
version V4.2.2 and above.