Repeat / Random mode
Press the Repeat/Random Button (7) before or during playback to cycle through different
Repeat/Random modes shown below:
PLAY MODE LED INDICATOR STATUS
REPEAT SINGLE TRACK FLASH IN RED COLOR
REPEAT ALL TRACKS LIGHT UP IN RED COLOR
RANDOM MODE LIGHT UP IN GREEN COLOR
OFF MODE TURNED OFF
Repeat play
There are two types of Repeat – Repeat 1 Track and Repeat All Tracks.
Random play
You can listen to all the tracks in a random order with this function.
Encoding (Recording) from PHONO/AUX to MP3 on USB
The system is able to encode music on vinyl records (Phono) to MP3 format on a connected USB flash
drive or SD/MMC card (supports maximum up to 2GB memory size).
PHONO ENCODING
1) Set the Function knob (5) to “Phono/Aux” mode and then press the “ Rec” Button(8).
2) The Record LED indicator (12) will light up. Now the system is ready to encode.
3) Start music playback from the vinyl record at the desired track.
4) After the music ends, press the “ Rec” Button (8) again to stop encoding.
NOTES:
- The recording speed is 1:1 and follows the actual play time of the music.
- The system will create a “AUDIO” folder and then save the newly encoded MP3s in it.
- The recording format is preset – MP3 bit rate: 128 KBPS, sampling rate: 44.1kHz.
- To stop recording, press the “ Rec” Button (8) again during recording mode.
- To avoid system confusion and causing it to choose incorrect media, please insert either one USB or
one SD/MMC Card only for recording. Otherwise, the system will select the recording media randomly.
AUX ENCODING
1) Connect the unit to other audio devices by connecting the Aux in jack (24)
2) Set the Function knob (5) to “Phono/Aux” made and then press “ Rec” Button(8).
3) The Record LED indicator (12) will light up. Now the system is ready to encode.
4) Start playback your external device to recording to USB or SD.
5) After recording finishes, press the “ Rec“ Button (8)again to stop the encoding.
TRACK SEPARATION (Start new MP3 File during encoding)
During encoding of Phono to USB drive/SD/MMC card, you can start a new MP3 file (eg. in between
songs) by pressing the “ “ (Track Separation) button once on the remote control. The Record LED
indicator (12) will flash once, the system will generate a new track and continue encoding.
DELETE TRACK (During MP3 playback)
You can delete a MP3 file from your USB/SD media device. Press and hold the delete button on the
remote control while the desired file is playing, and the Play LED indicator (13) will flash once to show that
the deletion is complete. The system will proceed to play the next file.
Line Out Connection
You can connect the system to your home Hi-Fi system by connecting the Line out Socket (23) to the
auxiliary input socket with a RCA cable (not included).
To Next Page
Loading...
