Teac MC-DV600 - Setting the Clock

19
Setting the Clock
When you connect the power cord into the wall socket and turn on
the unit for the first time, set the clock.
1
If the unit is on, press the STANDBY/ON button to put it in
the standby mode.
2
Press the CLOCK button.
< If “- -:- -” blinks on the display, press the CLOCK button again.
“Clock Set” appears on the display, and the “hour” value starts
blinking.
< When no button is pressed for 10 seconds, the time setting
mode will be cancelled.
3
Press the Volume (+ or –) button to set the current hour.
4
Press the CLOCK button.
The “minute” value starts blinking.
5
Press the Volume (+ or –) button to set the current
minute.
6
Press the CLOCK button.
The clock starts.
After the clock is set, also set the settings of the unit using the
SETUP menu (page 33).