Specifications
General
AC adapter power
Input .................. AC 100 V–AC 240 V, 50-60 Hz
Output. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 12 V, 500 mA
Power consumption
Standby. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 0.5 W or less
On (START) .............................. 1.5 W or less
Weight ................................4.9 kg (10 7/8 lb)
Operating temperature range .............. 5°C to 35°C
Dimensions (W × H × D) (including protrusions)
420 × 356 × 117 mm (16 5/8” × 14 1/8” × 4 5/8”)
o Performance data is specified at 20°C.
Included accessories
Rubber mat × 1
45 RPM adapter × 1
Counterweight × 1
Headshell × 1
AT95E MM cartridge (made by Audio-Technica)
preinstalled
Turntable × 1
Turntable cover × 1
Rubber feet for turntable cover × 2
Hinges × 2
Audio cable × 1
USB cable × 1
AC adapter (GPE053A-120050-Z) × 1
Owner’s manual (this document) × 1
Warranty card × 1 (for customers in the USA and
Canada only)
o Specifications and appearance are subject to change
without notice.
o Weight and dimensions are approximate.
o Illustrations in this owner's manual might differ
slightly from production models.
Turntable
Drive system ..................................Belt drive
Motor ........................................DC motor
Rotation speed .....................33 1/3 rpm, 45 rpm
Rotation speed variation ...........................±2%
Wow and flutter ...................................0.2%
SN ratio ....... 67 dB or higher (A-weighted, 20 kHz LPF)
Turntable ........................... Aluminum die-cast
30cm (12”) diameter
Tone arm
Arm type
Static-balanced straight-pipe tone arm
Effective arm length ........................... 223 mm
Stylus pressure variation range .................... 0–5 g
Acceptable cartridge weight .................. 3.5–6.5 g
Cartridge
Type ............................................... MM
Output voltage ........................... 2.5 mV ±3 dB
Stylus pressure .............................. 2.0 ±0.5 g
Cartridge weight ............................ 5.7 ±0.5 g
Included headshell weight .........................10 g
(including screws, nuts and wires)
Output voltage
PHONO EQ THRU ......................... 2.5 mV ±3 dB
PHONO EQ ON ...................... 155 mV (−16 dBV)
Output jacks ....................................... RCA
USB port
USB port that can receive power from computer USB
buses (Full Speed) ................USB connector type B
USB bus power support .................... 5 V, 500 mA
o Use the included USB cable to connect the unit to a
computer to receive power from it.
To Next Page
