Teac TTDEDS2018D - Initial Set-Up and Operation; Mains and Amplifier Connection; Playing a Vinyl Record; Connecting to Bluetooth Devices

PRODUCT DESCRIPTION
INITIAL SET-UP
MAINS CONNECTION
Ensure that the mains voltage of your home corresponds to the operang voltage of the
unit. Your unit is ready to be connected to a mains voltage of 220V-240V/50Hz.
AMPLIFIER CONNECTION
Whilst you can listen to your new turntable using the built-in speakers, you may wish to
connect it to your exisng Hi Fi system. Connect the audio plugs to the AUX input on your
mixer or amplier using an RCA cable (not supplied).
 Red plug into R/H channel input.
 White plug into L/H channel input.
Playing a record
 Place the record on the turntable. If required, do not forget to place the adaptor on the record
spindle.
 Choose the desired playing speed using the speed selecon switch between 33.3, 45 and 78rpm.
 Turn on the Rotary Power Switch, note that this also controls volume.
 Release the tone arm lock.
 Raise the arm with your hand lightly.
 Place the stylus vercally over the rst track of the record, the turntable will start turning
automacally.
 Lower the stylus slowly onto the record to play.
 When a record comes to the end, the turntable will stop automacally if the auto-stop switch
is in the ON posion. If the switch is in the o posion then it will keep revolving unl the tone
arm is returned to the tone arm rest.
 Li up the tone arm and put it on the rest when nished.
 Replace the protecve cap on the stylus and close the tone arm lock.
 Turn o the power at mains.
Connect to Bluetooth devices
Play from Bluetooth device:
1. Turn the AUTO STOP ON/OFF to “ON”.
2. Put the tonearm at the rest posion. Then you will hear a beep sound.
3. Then, acvate the Bluetooth funcon in your Bluetooth device (such as Mobile Phone or
tablet). The device will begin to automacally search for available nearby Bluetooth devices
to pair with.
4. Once the turntable is detected, your Bluetooth device will show “TTDEDS2018D” on the
list of nearby devices. Select it for pairing. Wait a few seconds and your Bluetooth device
will list it as connected.
5. Now you can start to play music on your Bluetooth device.