10 Copyright Team Orion © 2014
relative to the parameter you wish to modify, press the
SET button until the red LED starts ashing, indicating the
current setting for that parameter, one ash = setting one,
two ashes = setting two, etc.
E. Press the SET button to change the current setting value,
the ESC will loop through all the available values.
F. Once the red LED is ashing the number of times relative
to the setting you wish to use, press the SET button for 3
seconds. The setting is saved.
G. Switch o the ESC to exit programming mode
ADJUSTABLE PARAMETERS
Running Mode
“Forward Only with Brake” this mode is meant for
competition use. In this mode the car can go forward and
brake, there is no reverse.
“Forward/Reverse with Brake” this is the basic all-around
mode. In this mode the car can go forward and reverse
and can also brake. When you move the throttle to the
reverse position while the car is moving forward, brakes
are applied until the car is fully stopped, reverse cannot
engage while the car is moving. To engage reverse, once the
car has stopped, release the brakes and move the throttle
to the reverse position again. While braking or in reverse,
if the throttle is moved to the forward position, the car will
immediately accelerate forward.
Drag Brake Force
Sets the amount of brake automatically applied when the
throttle is returned to the neutral position. This simulates
To Next Page
Loading...
Need help?
General
