PIN-код
PIN-code — is a secret sequential combination of factory vehicle
button(s). Please check the Integrator for the list of buttons recognised
by the Alarm. PIN code is a one-, two-, three- or four-digit number.
Each digit is a number from 1 to 9
PIN code can be promptly changed numerous times by technical
specialists during Alarm installation or by you during day to day use
(refer to page 14).
To maintain proper security level factory PIN code has to be
changed.Until this is done signal will be emitted every factory PIN entry
as a reminder to change it
PIN-code entry sequence:
1. Turn on ignition or start the engine.
2. Enter PIN-code.
3. Wait for confirmation trill.
• Default PIN-code – "2", has to be entered from
programming button.
• It is impossible to set PIN "1" – single button press.
PIN-code examples
Buttons , , , , — used here as an example. Request the list of avaliable buttons in your vehicle at your shop .
One button PIN
One digit PIN-code: 2 digit PIN-code:
pause ~2 sec
Multiple buttons PIN-code (please, mind the sequence)
One digit PIN-code: 2 digit PIN-code:
pause ~2 sec
PUK-code
PUK-code – 4-digit number under the scrach layer on the plastic
card that came with the Alarm. PUK-code will disable all security
features of the alarm. Use PUK-code only if you lost PIN-code.
Input sequence:
1. Turn the ignition on or start the engine.
2. Enter PUK-code from programming button with 2 second pause
after each digit 2.
3. Wait for audio trill confirmation.
4. If you made a mistake, wait at least 3 seconds and repeat
PUK-code.
5. After succesful entry of the PUK-code you may enter new PIN-
code.
Maintenance mode
In this mode all antitheft and security features will be disabled.
Alarm will warn that maintanence mode is enabled by:
• LED flash after disarming
• LED goes off if ignition switched on
• Warning trill after PIN-code entry
• If the ignition turned off LED will light up for some time
To turn this mode on or off:
1. Turn on the ignition.
2. Enter PIN-code.
3. Press programming button 6 times (within 10 seconds after
PIN-code entry).
4. Wait for confirmation:
• Mode turned on – 1 audio and LED signal, trill
• Mode turned off – 2 audio and LED signal, trill.
Automatic turn off of the maintenance mode
This function will switch maintanence mode off if vehicle was
driven for 10 kilometers. If maintanence mode was switched on via
built it button it will not switch off automatically
If Speed Control is unavailable this feature will be disabled.
Additional functions
The alarm has additional features to raise security level.
Automatic window closing ("Comfort")
Alarm can be programmed to close all windows after arming the
alarm. This feature is not supported by all vehicles. Please check
Integrator.
Control of an electromechanical hood lock
The alarm allows to close hood lock when alarm is armed, and open
it with PIN-code.
Central lock control
If vehicle does not have:
1. Door locking on move .
2. Door unlock on Ignition off.
This can be done with the alarm.
This feature is not supported by all vehicles. Please check Integrator.
Control of a parking system
The alarm can control parking sensors in variety of ways. There are
3 operation modes
To Next Page
Loading...