EasyManua.ls Logo

Technaxx TE19 - User Manual

Technaxx TE19
72 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
Technaxx
®
* User Manual
Car Power Inverter with 2 USB Ports TE19
Do not use electric charge that need higher watts than
maximum 600W continuously !
This device is only suitable for vehicle with 12V electrical
systems!
The Declaration of Conformity for this device is under the Internet link: www.technaxx.de/
(in bottom bar “Konformitätserklärung”). Before using the device the first time, please read
the user manual carefully. Service phone No. for technical support: 01805 012643 (14
cent/minute from German fixed-line and 42 cent/minute from mobile networks). Free Email:
support@technaxx.de
Keep this user manual for future reference or product sharing carefully. Do the same with
the original accessories for this product. In case of warranty, please contact the dealer or
the store where you bought this product.
Warranty 2 years
Features
⚫ Charges various electronic devices in a car (12V fixed connection needed)
⚫ 2x USB port, (max. 3A)
⚫ 2x Schuko Plug with On/Off switch
⚫ Converts 12V DC battery power into standard 230V AC (household) power,
to run a variety of electronics, e.g. tablets, smartphones, laptop computers,
game systems, small TVs, DVD/MP3 players, camping accessories, GPS
units and much more
⚫ Output power 600W (max. continuous) and 1200W (peak)
⚫ Automatic safety shutdown to secure the car battery (Alarm at ~10.5V)
⚫ High/Low voltage & overload protection
⚫ Overheating protection (built-in ventilation fan)

Table of Contents

Questions and Answers

  • J
    Jeffrey BeanAug 11, 2025
    What to do if my Technaxx TE19 has no power?
    • P
      pgarciaAug 11, 2025
      If your Technaxx Inverter isn't powering on, there might be a few reasons: * A loose connection could be the issue. To resolve this, turn off the Inverter, and then check that all cables are securely connected to both the Inverter and the power source. * The battery voltage might be too low (below 10V). In this case, you should recharge or replace the battery. * The equipment you're operating might be drawing too much power. If this is the case, let the Inverter cool down, ensure it has adequate ventilation, and verify that the load doesn't exceed its maximum rating for continuous operation.
  • J
    Jason CallahanAug 17, 2025
    Why is the low voltage alarm always on for my Technaxx TE19 Inverter?
    • B
      Bradley OconnorAug 18, 2025
      The low voltage alarm on your Technaxx Inverter might be constantly on because of: * A power battery condition with voltage drops, which means you should replace the battery. * Inadequate power or voltage drops. In this case, check the condition of the battery cables and cable leads, and clean or replace them as necessary.
  • C
    Christopher CooperAug 27, 2025
    How to fix low power output on Technaxx TE19?
    • G
      Gregory JohnsonAug 27, 2025
      If your Technaxx Inverter has low power output: * The battery condition may be poor, so recharge or replace the battery. * There may be a fault connection. Ensure the battery and Inverter terminals are clean.
  • B
    Benjamin Rodriguez DDSSep 2, 2025
    What to do if the low voltage alarm turns on immediately on Technaxx Inverter?
    • A
      Anita ThorntonSep 2, 2025
      If the low voltage alarm turns on immediately on your Technaxx Inverter, recharge or replace the battery, or add additional batteries. If you are using a 12V DC plug, run the vehicle engine.

Technaxx TE19 Specifications

General IconGeneral
Input Voltage12V DC
Output Voltage230V AC
Continuous Power300W
USB Output5V
USB Current2.1A
Output Frequency50Hz
ProtectionOverload, short circuit, overheat

Related product manuals