Note: It is also possible to stop the automatic started video recording by
pressing OK button.
Manual On/Off
Long press the power button. The display will light on and the Technaxx
logo is shown. Shortly after the live image of the front and back camera are
shown.
Long press the power button again the device powers off.
Motion detection
The TX-124 supports motion detection via G-sensor. When motion
detection is enabled a moving process is recorded automatically when the
target is moved.
Manually start video recording
Press OK button to start video recording. The past record time is shown in
red while recording. Again, the loop recording applies.
Press OK button again to stop the video recording.
Video playback
Short press menu button now you are in playback mode.
Short press up/down key to select the file.
Short press OK button to play the selected video file.
Press menu button again to get back to live image.
Enter menu
Long press the menu button to enter the menu. In the menu you can go up
and down with the selection buttons. To change (enable/disable) the setting
press the OK button. If necessary choose from the sub menu the value by
confirming with OK button
To leave the menu and get back to live image press the menu button again.
To Next Page
Loading...
