GB
6
HOW TO SET THE PRESENT TIME
1. Press the button ST three times.
The time indication alone flashes.
2. Press the SET H button until the present time hour
is displayed. Press the SET M button until the
present time minutes are displayed. The display
will automatically stop flashing.
Verify that the unit is connected to the
main power and the STANDBY lamp is
light up.
1. Set the selector to COOL (symbol
on the display).
2. Press the +/- buttons (temperature
selection) to set the desired temperature
(the temperature range is between 32 °C
max. and 10 °C min.).
COOLING
THE DISPLAY SHOWS THE
SELECTED TEMPERATURE.
AFTER 5 SECONDS FROM THE
REQUIRED TEMPERATURE SETTING
THE DISPLAY WILL SHOW THE ROOM
TEMPERATURE AGAIN.
3. Press the FAN button to select the fan speed.
NOTE
C
1
3
2
2
1
HEATING
1. Set the selector to HEAT (symbol on the display).
2. Press the +/- buttons (temperature selection) to set the
desired temperature (the temperature range is between 32
°C max. and 10 °C min.).
THE DISPLAY SHOWS THE
SELECTED TEMPERATURE.
AFTER 5 SECONDS FROM THE
REQUIRED TEMPERATURE SETTING
THE DISPLAY WILL SHOW THE ROOM
TEMPERATURE AGAIN.
3. Press the FAN button to select the fan speed.
For several minutes after the start of heating operation, the
indoor fan will stop until the indoor heat exchanger coil has
warmed up sufficiently. This is because the COLD DRAFT
PREVENTION SYSTEM is operating. During this period,
the STANDBY lamp remains lit.
NOTE
AUTOMATIC OPERATION
1. Set the or selector to AUTO (symbol on
the display; also the symbol or remains
displayed).
2. Press the
+/- buttons (temperature selection)
to set the
desired temperature (the temperature range is between
32 °C max. and 10 °C min.).
When selecting “auto cooling” or “auto heating”
operation, the unit is set respectively in cooling or heating
mode adjusting the room temperature understood as
“perceived”. The perceived temperature depends on
the value of the room relative humidity, according to the
“humidex” index.
3. Press the FAN selector button to the setting you want.
THE DISPLAY SHOWS THE
SELECTED TEMPERATURE.
AFTER 5 SECONDS FROM THE
REQUIRED TEMPERATURE SETTING
THE DISPLAY WILL SHOW THE ROOM
TEMPERATURE AGAIN.
EXAMPLE: if the sensors indicate a temperature of 30°C
and a relative humidity of 50%, the temperature really
perceived by the human body is 36°C and the unit will
adjust the temperature according to this last value.
DOUBLING SPEED FUNCTION
This function allows to double the available fan speed,
slowing the fan automatically when the room temperature
is close to the set one.
To enable this function, follow the steps below:
1. Select the following settings on the remote control
unit:
• “Auto cooling” function
• Flap AUTO
• Set temperature 10°C
2. Simultaneously press and hold the I FEEL and FAN
buttons for at least 7 seconds.
3. Release the I FEEL and FAN buttons pointing the
remote control unit at the unit’s receiver. 3 beeps will
signal you that the function is active and the operation
led, when the unit is on, will flash with a frequency of
2 seconds ON, 2 seconds OFF.
4.
Select again the desired setting.
H
50rpm
∆T
H-
M
M-
L
L-
LL
LL-
1°C0 1,5°C 2°C
To Next Page
Loading...
