Technibel CAW Series - Care and Cleaning Procedures; General Cleaning Safety Warnings; Casing and Grille Cleaning; Flap Operation and Cleaning Cautions

GB
HOW TO REMOVE THE AIR INTAKE GRILLE
GRILLE
STRING
1. Detach the safety string from the frame (remember to
attach it again after cleaning or maintenance).
2.
Open the air intake grille
, hold it on and pull it toward
you to detach the two guides.
3.
Clean the grille gently using a soft sponge, or the like.
Then dry it with care.
Neutral detergent may be used to remove stubborn
dirt. Then rinse thoroughly with water and dry it.
9
CARE AND CLEANING
l
Maintenance operations must be carried out by specially
trained personnel.
l
For safety, be sure to turn the air conditioner off and also
to disconnect the power before cleaning.
l
Do not pour water on the indoor unit to clean it. This will
damage the internal components and cause an electric
shock hazard.
CASING AND GRILLE
Clean the casing and grille of the indoor unit with a vacuum
cleaner brush, or wipe them with a clean, soft cloth.
If these parts are stained, use a clean cloth moistened with
a mild liquid detergent.
l
Never use solvents, or harsh chemicals when cleaning
the indoor unit. Do not wipe the plastic casing using very
hot water.
l
Some metal edges and the vanes are sharp and may
cause injury if handled improperly; be especially careful
when you clean these parts.
WARNING
CAUTION
The air intake grille can be removed in order to wash it
with water.
OPERATION
SELECTOR
• Use the FLAP button on the remote control to adjust
the position of the flap. If you move the flap by hand,
the factual flap position and the flap position on the
remote control may no longer match. If this should
happen, shut off the unit, wait for the flap to close,
and then turn on the unit again; the flap position will
now be normal again.
• Do not have the flap pointed down during cooling
operation. Condensation may begin to form around
the air vent and drip down.
CAUTION
2. WHEN THE AIR CONDITIONER IS RUNNING
If you want to turn off the air conditioner push the
OPERATION selector with a pen until the OPERATION
lamp is turned off.
Power failure during operation.
In the event of power failure, the unit will stop. When the
power is resumed, the unit will restart automatically after
3 minutes.
NOTE
If you have lost the remote control unit or it has troubles,
follow the steps below.
1. WHEN THE AIR CONDITIONER IS STOPPED
If you want to turn on the air conditioner push the
OPERATION selector with a pen to select the desired
mode (COOL or HEAT).
OPERATION WITHOUT THE REMOTE
CONTROL UNIT
The air conditioner will start in HIGH fan speed.
The temperature setting is 25°C for cooling mode and
21°C for heating mode.
NOTE