Disconnecting the Speakon Cable
When the speakon cable is properly installed it will be locked into place.
To disconnect the speakon cable from the speakers pull on the metal portion of the connector to unlock the
connector, and while pulling this metal piece turn the connector to left (counter-clockwise).
Connecting the RCA MIX Output
The RCA MIX output is designed to pass through the input signals to another powered speaker, amplifier or
recording device.
This a passive signal, therefore it must be connected to an amplifier so that it can properly reproduce sound.
Connect the RCA MIX OUTPUT to the line input on another powered speaker, amplifier or recording device. This
will allow you to transfer the audio to another device.
NOTE: WHEN MAKING THESE CONNECTIONS THE POWER OF THE SPEAKER AND THE SIGNAL SOURCE
SHOULD ALL BE IN THE OFF POSITION WITH THE VOLUME LEVELS TURNED DOWN. ONCE THE UNITS
ARE ALL POWERED ON, SLOWLY INCREASE THE VOLUME TO AVOID DAMAGING ANY OF YOUR
EQUIPMENT.
To disconnect the speaker cable, while pulling on the metal tab
turn the connector to the left (counter-clockwise) and pull out
the connector.
The MIX OUTPUT will pass through a passive signal of all
the inputs (MIC1, MIC2, AUX, LINE, USB, SD & Bluetooth)
to another device.
To Next Page
Loading...
Need help?
General
