19
2 SETUP
DMS3-CTC-25-114 v1.0
2 On the MediaAccess Gateway, press and hold the WPS button for at least 5 seconds and then release it:
3 The WPS button LED starts blinking. This indicates that the MediaAccess Gateway is now searching for wireless clients that
are in registration mode.
4 The MediaAccess Gateway is now exchanging the security settings.
5 Your wireless client prompts you that it is now connected to the access point.
Troubleshooting
If you are having trouble connecting your wireless client via WPS, this may be caused by one of the following reasons:
WPS can not be correctly executed:
Configure your wireless manually. For more information, see “2.4.2 How to manually connect your wireless client” on page 20.
Your wireless client is out of range:
If possible move your wireless client closer to your MediaAccess Gateway or use a wireless repeater to extend the range of
your wireless network.
Another device is interfering on the selected wireless channel:
Change the wireless channel of your MediaAccess Gateway. For more information, see “Change the wireless channel” on
page 66.
To Next Page
Loading...
Need help?
General
