19
2 SETUP
DMS-CTC-20140127-0004 v1.0
3 The WPS button LED starts blinking. This indicates that the Gateway is now searching for wireless clients that are in
registration mode.
4 The Gateway is now exchanging the security settings.
5 Your wireless client prompts you that it is now connected to the access point.
Troubleshooting
If you are having trouble connecting your wireless client via WPS, this may be caused by one of the following reasons:
WPS can not be correctly executed:
Configure your wireless manually. For more information, see “2.4.2 How to manually connect your wireless client” on page 20.
Your wireless client is out of range:
If possible move your wireless client closer to your Gateway or use a wireless repeater to extend the range of your wireless
network.
Another device is interfering on the selected wireless channel:
Change the wireless channel of your Gateway. For more information, see “Change the wireless channel” on page 66.
To Next Page
Loading...
Need help?
General
